Modelling Points, Lines, Rays & Line Segments
Aim
Model a point, segment, line and ray with their symbols, and count lines through one and two points.
Apparatus
- Plain paper or a dot-grid notebook
- A sharpened pencil and a ruler (scale)
- Coloured sketch pens (at least 3 colours)
- A piece of thread or thin string (about 30 cm)
Procedure
- Press lightly with a sharp pencil to make a tiny dot. Label it P and write its symbol.
- Mark A and B 4 cm apart and join them with a ruler: line segment AB. Write its symbol.
- Stretch a thread from A to B and pull it taut. It lies along AB, the shortest path.
- Draw AB again, extend it beyond A and B, add two arrowheads: line AB. Write its symbol.
- From a starting point A draw through P, one arrowhead at the far end: ray AP. Write its symbol.
- Draw lines through one point, then try different lines through two points. Count them.

Interactive 3D Experiment
Loading simulation…
What to observe
- How many end points do a point, a segment, a line and a ray have?
- Does the taut thread lie straight along AB?
- How many lines pass through one point? Through two points?
- Why are ray AP and ray PA not the same?
Notes
- The rule that two points fix exactly one straight line is one of the oldest ideas in mathematics. It is in Euclid's Elements, written in Alexandria over 2000 years ago.
- Surveyors still use it every day when they stretch a string between two pegs to mark a straight edge.
- Symbols are a short code: a capital letter names a point, a bar names a segment, a double-headed arrow names a line and a single arrow names a ray.
- Press lightly with a sharp pencil, so the point stays a tiny dot and does not spread into a blob.
- Always use a ruler. A freehand 'straight' line will not match the taut thread.
- Pull the thread completely taut before comparing. A slack thread does not show the shortest path.
- Draw the arrowheads correctly: two for a line, one for a ray and none for a line segment.
- Mark and label the starting point of a ray clearly, because ray AP and ray PA are not the same.
- Label points with capital letters, and write the symbol beside each drawing as soon as it is made.